1. Input Voltage DC12V, single signal (DI) control.
2. Signal breakpoint transmission, any fault pixel won‘t affect signal transmission ,unless two consecutive adjacent fault LED。
3. WS2815 IC embedded in SMD5050 RGB LED. Each led is programmable.
4. 30leds/m,60leds/m,144leds/m available.
5. 33.3mm/1.31",16.6mm/0.65",6.9mm/0.27" intervals cutting point
6. White PCB/Black PCB available, IP21/IP65/IP67/IP68 available.
7. Both ends wired with 150mm/5.9" 20Awg wire and JST 4Pin male/female connector
8. 3M adhensive tape stick on the back of non-waterproof version.
9. Controller System：SD controller , DMX controller , Artnet.
10. Only DI wired to controller‘ data . BI is for the chip‘s breakpoint resume function when we resolder PCB
| Product Model | ||||||||||
| M/N | Size/mm | IP Rate | Voltage | Led type | IC type | Leds/m | Pixel/m | Luminous/m | Angle | Watt/m |
| GE30RGB2815A GE30RGB2815B GE30RGB2815C GE30RGB2815D |
5000*10*3.0 5000*10*3.5 5000*12*4.0 5000*12*4.0 |
IP21 IP65 IP67 IP68 |
DC12V | SMD5050RGB | WS2815 Built in |
30 | 30 | R: 75lm G:150lm B:60lm Mix W:240lm |
120 | 5.0w |
| GE60RGB2815A GE60RGB2815B GE60RGB2815C GE60RGB2815D |
5000*10*3.0 5000*10*3.5 5000*12*4.0 5000*12*4.0 |
IP21 IP65 IP67 IP68 |
DC12V | SMD5050RGB | WS2815 Built in |
60 | 60 | R: 150lm G:300lm B:120lm Mix W:480lm |
120 | 9.6w |
| GE144RGB2815A GE144RGB2815B GE144RGB2815C GE144RGB2815D |
5000*12*2.5 5000*12*3.0 5000*14*3.5 5000*14*4.0 |
IP21 IP65 IP67 IP68 |
DC12V | SMD5050RGB | WS2815 Built in |
144 | 144 | R: 360lm G:720lm B:288lm Mix W:1150lm |
120 | 22.0w |
ChatNow
Mail me